DEVICE OVERVIEW Device overview 5.8" and 6.5" TFT-LCD screen 5.8"/ 6.5" TFT LCD screen for headrests On/off switch Key for screen menu display (OSD menu) Up menu Down menu AV channel setting (AV1 - AV2 - ...) V DEO Headphone socket Video input (internal) Connecting cable Interface cable...
NOTES General information Thank you for choosing a Blaupunkt product. We hope you enjoy using this new piece of equipment. Please read these operating instruc- tions before using the equipment for the first time. The Blaupunkt editors are constantly working on making the operating in- structions clearer and easier to under- stand.
- IR remote control IVRC-06 Available accessories - Monitor bracket 7608009300 The installation instructions are included with the bracket. Note regarding VIDEO IN/AUX: Only use original Blaupunkt accessory 7 607 001 510. Or else use a mono plug. Fitting Monitor installation Note: It is recommended that the fitting is car- ried out at a specialist workshop.
FITTING Carefully cut open the headrest cover Use a knife with an adjustable cutting depth to cut out the planned area. Make the first cut inside the marked area at a point about 0.5 cm from one of the corners, then make a diago- nal cut to a point about 0.5 cm from the opposite corner.
Lay the cable through the headrest Now pass the supplied cables throu- gh the opening so that they emerge from the underneath of the headrest. If possible, cover the cable with a ca- ble tunnel. Now connect the power supply, ground and video signal cables, to check that the monitor is working.
FITTING Check and adjust the monitor then apply the Velcro strips Connect the monitor, place it tempo- rarily in the cut-out, and place the headrest into position. Check the various monitor settings such as brightness, headphone func- tion, volume control and so on. Then attach the Velcro strips to the rear of the monitor, and push the fra- me onto the headrest.
FITTING Negative (ground) connection Attach the negative cable (earth/GND) directly to the vehicle body using a screw. Scratch the surface down to the bare metal at the point at which the ground is made. • If the installation requires holes to be drilled or any other changes to be made to the vehicle, please contact a specialist workshop in your area.
OSD MENU OSD menu Operation Press the “MENU” button on the dis- play or on the remote control to open the OSD menu. Use the arrow buttons ect the options and after you press the MENU button you can use the arrow buttons settings.
IR remote control Functions The supplied remote control is suitable for operating the following monitors: IVMS-5802 and IVMS-6502. 1 POWER On/off button for the monitor. 2 TV/VIDEO No function. 3 VOL • arrow button Increase the volume for the sel- ected monitor.