10Base-T/100Base-Tx Mda; Figure B-1. 400-4Tx Mda Front Panel; Table B-1. 400-4Tx Mda Components - Bay Networks BayStack 350 Using Manual

Using the BayStack 350 10/100/1000 Series Switch

10BASE-T/100BASE-TX MDA

The 400-4TX MDA (see
(8-pin modular) port connectors to attach Ethernet
400-4TX MDA components and LEDs.
Figure B-1.
Table B-1. 400-4TX MDA Components
Item Label
1 100
2 10
3 F Dx
4 Activity
5
B-2
Figure
5
400-4TX MDA Front Panel
Description
100BASE-TX port status LEDs (green):
On: The corresponding port is set to operate at 100 Mb/s.
Off: The link connection is bad or there is no connection to this port.
Blinking: The corresponding port is management disabled.
10BASE-T port status LEDs (green):
On: The corresponding port is set to operate at 10 Mb/s.
Off: The link connection is bad or there is no connection to this port.
Blinking: The corresponding port is management disabled.
Full-duplex port status LEDs (green):
On: The corresponding port is in full-duplex mode.
Off: The corresponding port is in half-duplex mode.
Port activity LEDs (green):
Blinking: Indicates the network activity level for the corresponding port. A
high level of network activity can cause LEDs to appear to be on
continuously.
10BASE-T/100BASE-TX RJ-45 (8-pin modular) port connectors.
B-1) uses four 10BASE-T/100BASE-TX RJ-45
devices.Table B-1
1 2
100
10
F Dx
Activity
400-4TX MDA
4 3
BS35042A
describes the
304376-B Rev 00