Example Of Configuring System Identification; Configuring The Time Zone - Nortel COMMISSIONING 8600 Commissioning

Example of configuring system identification

Procedure steps
Step
1
2
3
Configuring the time zone
Configure the time zone to specify the time zone for your location and
configure settings for Daylight Saving Time (DST).
Prerequisites
•
Procedure steps
Step
1
2
3
Variable definitions
Use the data in the following table to use the boot config tz command.
Copyright © 2008 Nortel Networks
.
Action
Change the system name by using the following command:
ERS-8610:5(config)#sys name ERS-8610
Configure the system contact by using the following command:
ERS-8610:5(config)#snmp-server contact
joe.smith@somecompany.com
Configure the system location by using the following command:
ERS-8610:5(config)#snmp-server location "12 Main
St, Vancouver, BC"
You must log on to the Global Configuration mode in the NNCLI.
Action
Configure the time zone by using the following command:
boot config tz
Save the changed configuration to the boot.cfg and pcmboot.cfg
files.
Reboot the switch.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008

Configuring the time zone 89

--End--
--End--