Example Of Assigning A Static Route To The Management Interface; Enabling Remote Access Services - Nortel COMMISSIONING 8600 Commissioning

118 Remote connection configuration using the NNCLI
Variable definitions
Use the data in the following table to use the boot config net mgmt
route command.
Variable
gateway
netaddr/mask

Example of assigning a static route to the management interface

Procedure steps
ATTENTION
The config net mgmt route command uses the natural mask of the target
subnet. Therefore, in the preceding example, what you implement is the
command:config net mgmt route 13.0.0.0 10.125.2.1. Additionally, this
route does not appear in the routing table of the Nortel Ethernet Routing Switch
8600. If you configure a 13.x.x.x network for output using the I/O modules, the
switch can experience connectivity issues.

Enabling remote access services

Enable the remote access service to provide multiple methods of remote
access.
Prerequisites
•
•
Copyright © 2008 Nortel Networks
.
Action
If you locate a management station on the network of
11.0.0.0/255.0.0.0, and the next hop to that network from the
management interface is 10.127.231.1, enter the following
command to configure the management port:
ERS-8606:5(config)#boot config net mgmt route
11.0.0.0/255.0.0.0 10.127.231.1
The value 11.0.0.0/255.0.0.0 represents the target subnet; the
value 10.127.231.1 represents the gateway used to point to the
target subnet.
When you enable an rlogin flag, you must configure an access policy
to specify the user name of who can access the switch. For more
information about the access policy commands, see Nortel Ethernet
Routing Switch 8600 Security, NN46205-601.
You must log on to the Global Configuration mode in the NNCLI.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Value
Configures the IP address of the
default gateway.
Configures the IP address and mask
of the destination network in the
formats a.b.c.d/x | a.b.c.d/x.x.x.x |
default.