.
Common procedures using the CLI
The following section describes common procedures you use while
commissioning the Nortel Ethernet Routing Switch 8600.
Common procedure navigation
•
Saving the configuration
After you change the boot configuration, you must save the changes
to both the master and the standby management modules. Save the
configuration to a file to retain the configuration settings.
Procedure steps
Variable definitions
Use the data in the following table to use the save command.
Variable
backup
<value>
Copyright © 2008 Nortel Networks
.
"Saving the configuration" (page 129)
Action
Save to configuration by using the following command:
save <savetype> [file <value>] [verbose] [standby
<value>] [backup <value>] [mode <cli|nncli>]
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Value
Saves the specified file name and
identifies the file as a backup file.
value uses one of the following
formats:
•
/pcmcia/ <file>
•
/flash/ <file>
file is a string of 1–99 characters.
129