Table of Contents
Advertisement
Table 13
Job aid: Setup utility prompt descriptions (cont'd.)
Prompt
IP address of the default VLAN
[0.0.0.0/0.0.0.0]:
Do you want to save the
changes
[Saving the parameters
updates the files /flash/boot.cfg
and /flash/dvmrp_pol.cfg]
(y/n)?
Configuring system identification
Configure system identification to specify the system name, contact
person, and location of the switch.
Prerequisites
•
Procedure steps
Step
1
2
3
Variable definitions
Use the data in the following table to use system-level commands.
Variable
agent-conformance
Copyright © 2008 Nortel Networks
.
You must log on to the Global Configuration mode in the NNCLI.
Action
Change the system name by using the following command:
sys name <word>
Configure the system contact by using the following command:
snmp-server contact <word>
Configure the system location by using the following command:
snmp-server location <word>
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Configuring system identification 87
Description and action
Description: Specifies the IP address of the
default Virtual Local Area Network (VLAN).
Action: Type the IP address of the default
VLAN.
Description: Saves your changes to the boot
and run-time configuration files.
Action: Enter y to save the boot and run-time
configuration files. Enter n if you do not want
to save your changes.
--End--
Value
Enables agent conformance mode.
Advertisement
Table of Contents
