Specifying The Primary Sf/Cpu; Changing Passwords - Nortel COMMISSIONING 8600 Commissioning

64 Initial steps using the CLI

Specifying the primary SF/CPU

Specify the primary SF/CPU to determine which SF/CPU you use as
the primary after the switch performs a full power cycle only. When the
SF/CPU becomes the primary, the master LED for the SF/CPU is on.
Procedure steps
Step
1
2
3
4
Variable definitions
Use the data in the following table to use the config bootconfig
master command.
Variable
<cpu-slot>

Changing passwords

Configure new passwords for each access level, or change the logon or
password for the different access levels of the switch. After you receive
the Nortel Ethernet Routing Switch 8600, use default passwords to initially
access the CLI. If you use Simple Network Management Protocol version 3
(SNMPv3), you can change encrypted passwords.
Copyright © 2008 Nortel Networks
.
Action
Configure the date by using the following command:
config setdate <MMddyyyyhhmmss>
Action
View the current setting for the primary SF/CPU by using the
following command:
show bootconfig master
Specify the slot of the primary SF/CPU by using the following
command:
config bootconfig master <cpu-slot>
Save the configuration to the boot.cfg and pcmboot.cfg files.
Reboot the switch.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
--End--
Value
Specifies the slot number for the
primary SF/CPU. This variable can be
5 or 6. The default primary is slot 5.