Contivity 4500 Option Installation; Opening The Contivity 4500; Removing The Contivity 4500 Front Bezel - Nortel 2500 Installation Hardware

Contivity vpn switch

Hide thumbs Also See for 2500:

Table of Contents

Chapter 2

Contivity 4500 Option Installation

This section describes how to install or replace hardware components for the

Contivity 4500.

To replace power supplies, replace hard disk drives, or access the Contivity 4500's

diskette drive for system recovery operations, you must remove the switch's front

bezel. To install LAN or WAN cards, or install additional memory, you must

remove the front bezel and then remove the switch's top cover as well.

The first few times you remove the front bezel it will be somewhat difficult to

remove. This is because the ball stud and sockets are new. After a few times,

removal is easier. Remove the switch's front bezel as follows:

Warning: Wear an antistatic band when handling electronic

components for the Contivity switch to avoid damaging them.

Note: Turn off the Contivity switch and unplug it before installing LAN

or WAN cards, or system memory.

Note: Removing the front bezel on the Contivity 4500 system activates

the chassis intrusion alarm only if the switch is turned on. This intrusion

is reported to the system log file.

Installing Hardware Options for the Contivity VPN Switch

Table of Contents

2600 4000 600 Centillion 1600 Nortel contivity extranet switch 4500