Cabling The System Monitor - Nortel 1000M Installation And Commissioning Manual

Table 11
SW2 on slaves—total unit number for the slaves (Part 2 of 2)
Slave unit
address
3
31 on
Note: **Slave addresses are 1-63.

Cabling the System Monitor

Communication Server 1000M and Meridian 1
Switch position
4 5 6 7
off off off off
The System Monitor (NT8D22) is used to monitor the temperature, power
supplies, and blower unit in a column. A series of daisy-chained flat-ribbon
cables between each module is used to connect the power supplies and the top
cap thermal sensors to the system monitor located in the pedestal. The flat
cable routes through the square holes in the rear horizontal cable trough.
Figure 63 shows the cabling of the system monitor in a column.
Configuring the system monitor
Slave unit
address
8
off 63
End of Procedure
Large System Installation and Commissioning
Page 157 of 456
Switch position
3 4 5 6
off off off off
7 8
off off