2Xgigabit Ethernet/Fibre Channel - Point-To-Point Circuit Pack; Equipping Rules - Nortel NTRN10AN Planning Manual

3-98 Hardware feature descriptions
Alarm LED definitions
The following table provides a list of the OPTera Packet Edge 2xGigE circuit
pack LEDs. See
LED
Status
Active
WAN
Link (1-2)

2xGigabit Ethernet/Fibre Channel - Point-to-Point circuit pack

(NTN438DA)
The 2xGigE/FC-P2P circuit pack also provides 2 independent LAN ports
allowing for transport of Gigabit Ethernet or Fibre Channel signals across a
SONET network where the traffic can be groomed, switched and monitored by
the network,
The 2xGigE/FC-P2P circuit pack allows a fiber LAN tributary interface to
connect directly to the circuit pack faceplate. The 2xGigE/FC-P2P circuit pack
supports contiguous and virtual concatenation connections, refer
management on page 2-84

Equipping rules

The OPTera Metro 3500 shelf supports eight OPTera Packet Edge
2xGigE/FC-P2P circuit packs in slots 3 through 10. 2xGigE/FC-P2P circuit
packs only operate in an unprotected mode.
Users can install only 2x100BT-P2P, 4x100BT, 4x100FX and 2xGigE/FC-P2P
circuit packs in adjacent slots.
OPTera Metro 3500 Multiservice Platform
Figure 3-28 on page 3-47
Color Description
Red When active, indicates that a circuit pack
equipment failure has been detected.
Green When active, indicates that the circuit pack is
active and either at least one of the LAN ports is
IS (Data) or at least one cross-connect exists
(SONET).
Yellow Active when the circuit pack has at least one
cross-connect and is attached to an OPTera
Packet Edge System ring and either the east,
west, or both WAN ports are experiencing an
STS path problem.
Yellow Active when the administrative state of one of
the two LAN ports is up and the operational state
is down.
NTRN10AN Rel 12.1 Standard Iss 1 Apr 2004
for the 2xGigE faceplate layout.
Bandwidth