Path Trace For; Section Trace For; Section Data Communication Channel (Sdcc); Forward Error Correction (Fec) - Nortel NTRN10AN Planning Manual

3-60 Hardware feature descriptions
Table 3-8
OC-192 optical wavelength
OC-192 circuit pack
Intermediate Reach (IR)
Long Reach (LR)
DWDM Long Reach (LR)
STS-1 path trace for OC-192
OPTera Metro 3500 supports path trace capability for OC-192 services. Path
trace is a 64 byte ASCII string that can be provisioned by the user. Path trace
is transmitted through the J1 byte of the STS Path Overhead. It can be used by
STS path terminating equipment (PTE) to verify its continued connection to
the intended transmitting STS PTE.
Section trace for OC-192
OPTera Metro 3500 supports section trace capability for OC-192 services.
Section trace provides a diagnostic tool that can determine installation and
commissioning problems such as misconnected optical fibers. Section trace
occupies the J0 SONET byte (formerly known as the C1 byte to indicate the
STS-1 ID) of the section overhead. Section trace is injected at the transmit end
of a section and extracted at the receive end where it can be checked against an
expected section trace value.

Section data communication channel (SDCC)

A DWDM OC-192 line carries a DCC channel that can be edited, provisioned,
and deprovisioned.

Forward Error Correction (FEC)

Forward error correction detects and corrects small burst errors of 8 bits on an
STS-48 basis. The FEC feature adds some redundancy parity bits on the
transmit side and removes the bits on the receive side. The OC-192 DWDM
G.709 FEC interface supports standard encoding and decoding RS-8
(Reed-Solomon) as specific in ITU-T G.709/Y.1331 standards.
OPTera Metro 3500 Multiservice Platform
Wavelength
1550 nm
1550 nm
See Dense wavelength division
multiplexing (DWDM) on page 2-46
Note 1: The maximum number of simultaneous SDCC-provisionable
ports on an OPTera Metro 3500 shelf is 34 (the shelf must be equipped with
eight unprotected OC-3x4 or OC-12x4 STS circuit packs in slots 3 through
10, and a protected pair of OC-48 or OC-192 circuit packs in slots 11 and
12).
Note 2: For Nortel Networks interworking and multi-vendor network
scenarios, DCC interoperability can be achieved with the appropriate
provisioning. See Optical Networks Data Communications Network
Planning Guide, NTR710AM.
NTRN10AN
Line rate (Gbit/s)
9.953
10.709
10.709
Rel 12.1 Standard Iss 1 Apr 2004