Optera Packet Edge System 4X100Bt Circuit Pack; Equipping Rules - Nortel NTRN10AN Planning Manual

3-94 Hardware feature descriptions

OPTera Packet Edge System 4x100BT circuit pack

(NTN433BB)
Each OPTera Packet Edge System circuit pack works as a distributed switch
and bridge to connect Ethernet LANs on a high-speed SONET network.

Equipping rules

Each OPTera Packet Edge System 4x100BT circuit pack requires an
8xRJ-45 Front I/O module (NTN452NA) on the OPTera Metro 3500 Shelf
(NTN476AA, NTN476DA). On the OPTera Metro 3500 Universal Shelf
(NTN476AH) you must use the 8xRJ-45 Front Enhanced I/O module
(NTN452NH) or the 8xRJ-45 Rear I/O module (NTN452HB).
Both versions of the shelf support eight OPTera Packet Edge System 4x100BT
circuit packs in slots 3 through 10. 4x100BT circuit packs only operate in an
unprotected mode.
If a 2x100BT-P2P, 4x100FX, 4x100BT or 2xGigE/FC-P2P circuit pack is
inserted into an odd slot (n
circuit packs into the even slot (n
•
•
•
•
If a 2x100BT-P2P, 4x100FX, 4x100BT or 2xGigE/FC-P2P circuit pack is
inserted into an even slot (n
circuit packs into the odd slot (n
•
•
•
•
See
OPTera Metro 3500 Multiservice Platform
2x100BT-P2P
4x100BT
4x100FX
2xGigE/FC-P2P
2x100BT-P2P
4x100BT
4x100FX
2xGigE/FC-P2P
Note: There is no equipment protection for the 4x100BT circuit pack.
Table 3-3 on page 3-6
Note 1: If there is a 1-28 DS1 I/O module installed, and if slots 5 and 6 are
not equipped with DS1 mappers, you may not install 4x100BT circuit
packs in slots 5 or 6 (there is not enough room for slot 5 or slot 6's 8xRJ-45
I/O modules).
Note 2: If there is a 29-56 DS1 I/O module installed, and if slots 7 and 8
are not equipped with DS1 mappers, you may not install 4x100BT circuit
packs in slots 7 and 8 (there is not enough room for slot 7 or slot 8's
8xRJ-45 I/O modules).
NTRN10AN
), then you can only insert one of the following
odd
+1):
odd
), then you can only insert one of the following
even
-1):
even
for operational temperature ranges.
Rel 12.1 Standard Iss 1 Apr 2004