Nni Filters Increased To 2048; Optical Ethernet-Private Line (Oe-Pl) Services Using 10/100 Ethernet; 2X100Bt-P2P Circuit Pack - Nortel NTRN10AN Planning Manual

2-66 Operation, administration, and maintenance (OAM) features

NNI Filters increased to 2048

•

Optical Ethernet-Private Line (OE-PL) services using 10/100 Ethernet

One of the key services within Optical Ethernet is the Private Line (OE-PL)
Service. An Ethernet private line has the same service characteristics as a
traditional TDM based DS1, DS3 or OC-n private line service but uses Native
Ethernet as the interface. Ethernet frames are relayed transparently between
two Ethernet ports. The Ethernet frames are mapped into circuits either at full
or partial rate.
End users can benefit from Native Ethernet interfaces and no longer require
any adaptation to traditional WAN interfaces (T1/DS1, T3/DS3, OC-n). This
simplifies the co-ordination of interfaces between the Carrier and Enterprise,
and moves to a simple 'plug-and-play' model for WAN services based on
Ethernet 802.3.
The 2x100BT-P2P circuit pack available on OPTera Metro 3500 are used to
offer OE-PL service.

2x100BT-P2P circuit pack

The 2x100BT-P2P circuit pack has the following functionality:
•
•
•
•
•
•
•
The 2x100BT-P2P circuit pack separately maps two 10/100BASE-T ports into
STS-1/STS-3c SONET signals for transport across a SONET domain. The
2x100BT-P2P circuit pack has two logical sides to its interface: the LAN side,
which contains the Ethernet ports; and the WAN side, which interfaces with
the STX and VTX-series circuit packs at the SONET level. Four MAC
addresses are allocated for each 2x100BT-P2P circuit pack.
OPTera Metro 3500 Multiservice Platform
OPTera Metro Release 12.0 augmented the number of individual NNI
filters to 2048. The 2048 filters are shared across any Ethernet ports on the
4x100BT, 4x100FX and 2xGigE cards which are configured as NNI.
Dedicated private point-to-point Layer 1 connectivity using standard
STS-1 or STS-3c connections
Same look and feel as other OPTera Metro 3500 TDM tributaries such as
DS3 or EC-1
2 x 10/100 LAN ports independently configurable as 10BASE-T or
100BASE-TX
Capability to interconnect back-to-back the Ethernet interfaces of the
2x100BT cards
Network protection using UPSR, BLSR, and 1+1 linear
Fully managed through Site Manager (does not support SNMP/ BCC as in
the case of OPE circuit packs)
Ethernet and WAN Operational Measurements
Note: The 2x100BT-P2P circuit pack only supports far-end link
conditioning at 100 Mb/s (100BASE-TX).
NTRN10AN Rel 12.1 Standard Iss 1 Apr 2004