Equipping Rules; Ilan Interface; Oc-192 Optical Interface Circuit Pack - Nortel NTRN10AN Planning Manual

Equipping rules

The NPx must be installed in slot 16. See
temperature ranges.
Alarm LED definitions
The following table provides a list of LEDs on the NPx circuit pack.
LED
Status
Active

ILAN interface

(NTN425AA)
The ILAN circuit pack (NTN425AA) provides the Ethernet hubbing
functionality required to interconnect OPTera Metro 3000 shelves. The ILAN
circuit pack provides a low cost solution to Ethernet connectivity between
OPTera Metro, OC-48 Classic Phoenix SP, OPTera Connect DX and OPTera
Long Haul OPCs and the OPTera Connect HDX as well as the capability to
daisy-chain up to 16 shelves. The ILAN interface gives the user access to
ILAN ports 1 and 2 on the LOAM.
Equipping rules
The ILAN circuit pack must be inserted in slot 16. See
for operational temperature ranges.

OC-192 optical interface circuit pack

(NTN445CB, DA)
The main transport OC-192 circuit pack operates at an OC-192 line rate (9.953
Gbit/s for IR and 10.709 Gbit/s for LR and DWDM). The OC-192 circuit pack
can be installed in slots 11 and 12 in a UPSR, 1+1 linear system and BLSR. In
the 1+1 linear protection scheme, OC-192 circuit packs can be provisioned in
either unidirectional or bidirectional mode. See
operational temperature ranges.
See
the transmit and receive optical circuit packs.
Planning and Ordering Guide—Part 1 of 2 NTRN10AN
Color
Red
Yellow
Green
Note: The ILAN interface circuit pack does not give the user access to
COLAN ports.
Table 3-9 for the OC-192 optical wavelengths and line rates supported for
Hardware feature descriptions 3-59
Table 3-3 on page 3-6
Description
Circuit pack failure, reset or insertions
Facility failure
In service
Table 3-3 on page 3-6
Rel 12.1 Standard Iss 1 Apr 2004
for operational
Table 3-3 on page 3-6
for