Cleaning By Hand; Cleaning By Hand With Liner - DeVilbiss OMX-5 Owner's Manual

CLEANING BY HAND
WARNING
flammable vapors. Risi{ of fire or
explosion. Provide ample ventila-
tion.
WARNING
Toxic vapors and liquids. Risk of
personal injury. Use personal
protective equipment specified lUi
the Msterial Safety Data Sheet
for each material.
WARNiNG
Risk og equipment damage. Do
not soak gun in solvent. Solvent
soaking adversely affects all guns
by removing lubrication a.nd caws-
ing possible damage to seals. For
spacial cleaning situations,
con-
tact DeVIlbiss Customer Service
a! 1-800-445-3988 (U.S. and
Canada only}.
Note
The gun's grips can be removed
and soaked in solvent.
Read Safety Precautions on Page 2. Hand
cleaning is recommended and is an accept-
able procedure in most areas. Check your
local air quality regulations if you are un-
sure as to what is acceptable in your area.
Use only paint solvents that comply with
local regulations. Dispose of paint accord-
ing
to all
environmental regulations.
Note
Always use the cleaning brushes
where indicated. This
will remove
clear coat that is difficult to see,
but could cause problems
if
not
removed.
Note
Normal cleaning does not require
removal of the gun's spray head.
CLEANING BV HAND WITH liNER
/1) Disconnect the air hose and remove
the paint cup lid.
111
\
\
(2) While holding disposable liner, point
gun upwards and pull trigger until
fluid tube is empty. {This allows paint
in gun to drain into the liner.)
Watch For
Empty Tube
Hold Llner
121
(3) While still pointing the gun upwards,
CCL"Dfully pull out liner. Keep drain
bushing up to prevent ieaking, To
prevent paint from being forced out
of bushing, don
1
t squeeze the liner
while handling it.
[ ]
(3)
Keep Bush1ng
/Up
SB·2-230·E Page 9
Note
If there
is
a large amount of paint
in paint liner, open zipper and
empty paint
before
removing liner.
(4) Properly dispose of remaining paint in
paint liner, Open zipper to allow for
quicker draining of paint. Dispose of
used liner and bushing • Do Not Re-
use.
Note
If drain bushing remains in cup
drain, use needle nose pliers to
remove. See Step 6 below for
proper cleaning.
Waste Paint
Container
141
(5) Pour a small amount of clean paint
solvent into paint cup.
(51
rrr
(6) Clean drain hole and fluid tube with
tube brush. Drain hole must be ){ept
clean for proper sealing and easy
removal
oi drain bushing. Twirl brush
in drain hole.
Hold Tube Brush
Here When Installing
Into Drain Hole
l
I