Table of Contents
Advertisement
Page 34 SB-2·230-E
MISCELLANEOUS PARTS D/SASSEMBLY/ASSEMBL Y (See Page 15 for Parts Replacement}
Miscellaneous Parts Removal
a
Air Inlet Fitting &
Rear
Air Plug
Horn Air Knob
Gun Repair Kits
AIR INLET FITTING
Tools Required
o
1/8" (3
mm) wide flat blade screwdriver & 1/4" (6 mm) w'1de flat blade screwdriver
~
Special tool re.·uired that is included with repair kit
o See a!! appropriate sections
1.
Remove grips
e
See Page 22.
2.
Remove spring clip.
<~~
Note proper position of clip
3.
Twist inlet fitting to pull out
"
Note location of O·rings. Check for damage.
a
Replace O·rings
if swollen and can't be reassembled. Middle groove is for clip only.
4.
Push into gun and instal! spring clip,
e
Make sure clip fits tight.
6,
Assemble grips.
e
See Page 22, Step 6.
1.
Remove grips.
Q
See Page 22.
2.
Remove spring dip
"
Note proper position of clip
3.
Twist rear air plug to pull out
e
Check 0-ring for damage
0
Replace 0-ring
if
swollen
and can't be assEimbled.
4.
Push in r8ar air plug untit flush with
o
Make sure clip fits tight
rear of skeleton and the groove
lines up in hole for spring clip. Install
dip.
5,
Assemble grips.
"
See Page 22, Step 6,
HORI\I AIR KNOB
The horn air knob does not need to be removed unless air leakage is observed. A special tool and instructions are included with
replacement part.
GUN REPAIR KITS
Refer to Pages 32 & 33 for the exploded view and parts listing for the contents of I<K-5028 and KK-5031.
Advertisement
Table of Contents
