Troubleshooting - Beem Café Joy V2 User Manual

EN
The following table will help you locate and eliminate minor faults:
Fault
No symbol in the display.
The fuse in the fuse box
blows.
It is not possible to prop-
into the brewing position.
The coffee runs very
slowly into the glass jug.
No water runs out of the
appliance despite pumping
noise.
The coffee runs onto the
hot plate.
Water runs out of the
appliance.
Water runs out of the
strainer holder.
BEEM - Elements of Lifestyle

Troubleshooting

Possible cause
Not plugged in.
No mains power.
Display is defective.
Too many appliances connect-
ed to the same power circuit.
No fault detected.
holder.
Drip-stop is blocked.
Appliance is scaled.
No water in the tank.
Glass jug is not properly
placed.
Too much water in the water
tank.
Drip tray is full.
No fault detected.
The edge of the strainer
holder is soiled by coffee
residues.
Café Joy V2
Remedy
Insert the mains plug.
Check the fuse/mains
socket.
Contact customer
service.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
Insert the permanent
the section Inserting
(page 31).
Clean the drip-stop.
Descale the appliance.
Fill with water.
Place the glass jug in
the middle under the
tank.
Empty the drip tray.
Contact customer
service.
Clean holder and
strainer insert.
43