Beem Café Joy V2 User Manual page 44

EN
Push the drip-stop (19) several times
during rinsing.
Wipe the hotplate (17) carefully with
a damp cloth. Do not use abrasive
cleaning agents.
the section Inserting the permanent
31).
pliance until it stops.
Espresso machine
Emptying/cleaning the strainer insert
Take the strainer holder (12) with
the strainer insert (13) out of the
appliance as described in the sec-
tion Removing the strainer holder
(page 34).
Fold up the retaining bracket on the
handle of the strainer holder (image
F1).
Fold up the retaining bracket, hold the
coffee grounds out of the strainer in-
sert (13) over a waste bin (image F2).
NOTE
Use a spoon if the coffee grounds do
not fall out.
Take the strainer insert (13) out of the
strainer holder (12) as described in
the section Removing the strainer
insert (page 34).
Rinse the strainer insert and holder
under running water.
BEEM - Elements of Lifestyle
NOTE
The strainer insert can also be
cleaned in the dishwasher.
Rinse the polished aluminium
strainer holder by hand since it is
can lose its gloss or discolour.
Do not put the strainer holder (12)
back into the machine it is not to be
used for a longer period of time. This
-
increases the service life of the seal.
Cleaning the steam nozzle
In order to avoid clogging, the steam noz-
zle must be cleaned after each use:
Pull the froth attachment out down-
wards and clean it by hand or in the
dishwasher.
Fill a suitable container up to a half
with water and immerse the steam
nozzle into it completely.
Switch on the steam nozzle for ap-
prox. 20 seconds.
You can also clean the froth attach-
ment with warm water and washing-
NOTE
If the steam nozzle has become
clogged, you can clear the clogging
with a needle.
Café Joy V2
39