Operation - Fagor CA-80 C Instructions For Use Manual

• Do not cover the cord, for example with
a rug or similar. Place the cord far away
from any walk way or anywhere where
people might trip over it.
• In order to ensure the air grille does not
become blocked, keep the fan at least
20 cm away from the wall.
• Do not place the fan beneath curtains
or similar.
• Do not introduce any objects into the
grille.
• Do not leave the appliance next to any
focus of heat or on hot surfaces.
• Do not direct the flow of air directly
towards babies or ill persons.
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance
by a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device
(RCD) with an operational residual
current not exceeding 30 mA. Ask your
installer for advice.
4. ASSEMBLY
A. Fit the two parts of the base column (3)
together as shown in Fig. 2. Thread the
cable through the central hole and align
the screw holes on the base column
(3) with those of the fan. Then insert
the screws and tighten them with a
screwdriver (Fig. 3).
B. Fit the two parts of the base (4) together
as shown in Fig. 4. Thread the cable
through the central hole in the base.
Align the screw holes on the base with
those of the fan. Then insert the screws
and tighten them with a screwdriver.
(Fig. 5)
C. Position the cable in the groove on the
base (Fig. 6).

5. OPERATION

Before operating the fan, place it on a flat,
stable surface.
The fan may be controlled using the
buttons on the control panel or the remote
control as it has the same functions.
Switching the fan on and off: Press
the On/Off button (8) on the control
panel or on the remote control, to
start up the fan. Press this button
again to switch it off.
Speed setting: Press the speed
setting button (9) to select the air
flow rate. When you switch on the fan
the set speed will be "low" (I). Press
the button once to set a "medium (II)
speed, twice for "high" speed (III), and
three times to return to "low" speed
(I).
|
➞ Low speed
||
➞ Medium speed
|||
➞ High speed
According to the speed you have selected,
the light indicator corresponding to this
speed will light up.
MODE Ventilation type:
When you switch on the fan, "normal"
mode ( ).
The fan will run continuously at the speed
selected. Press the MODE button once to
set "natural" mode (
"night" mode (
mode, press the MODE button (10) a third
time. The indicator light for each ventilation
type will light up.
Oscillation: Press the oscillation
button (6) to make the fan oscillate
horizontally and thereby cool larger
spaces more efficiently. If you wish to
stop oscillation, press the same button
again.
Timer: Pres the timer button (7) if you
wish to select an operating period
9
) and twice to set
). To return to "normal"