Samsung DMT300 Series Service Manual page 27

2. Remove the water supply line (and elbow)
CAUTION
Make sure to close the faucet before removing the
water supply line.
3. Remove the four (4) screws on both sides of the bracket
front lower.
Remove the bracket front lower after the guide wire's 4
hooks release .
CAUTION
If the legs are in the way removing the screws,
unfasten it a little in the clockwise direction and
remove the screws.
Copyright© 1995-2010 SAMSUNG. All rights reserved.
4. Remove the two (2) screws and ground wire screw from
the inlet valve.
5. Hold and lift up the inlet valve and release flow meter's
clasp on the bottom of the base.
CAUTION
When release flow meter's clasp, push-up using tool.
6. Pull out the inlet valve until the hose clamp can be
removed, and remove the clamp and hose.
CAUTION
Take care when holding and removing the clamp with
a tool, as it may bounce and harm you.
3. Disassembly and Reassembly
3-18