D-Link X-STACK DES-3200 SERIES Reference Manual page 102

Hide thumbs Also See for X-STACK DES-3200 SERIES:
Table of Contents

Advertisement

®
xStack
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
DES-3200-28P:admin#show flow_meter
Command: show flow_meter
Flow Meter Information
------------------------------------------------------------------------------
Profile ID:1
Aceess ID:1
CIR(Kbps):1000
Action:
Conform : Permit
Exceed : Permit
Violate : Drop
------------------------------------------------------------------------------
Total Entries: 1
DES-3200-28P:admin#
6-7
config time_range
Description
This command is used to define a specific range of time to activate a function on the Switch by
specifying which time range in a day and which days in a week are covered in the time range. Note
that the specified time range is based on the SNTP time or the configured time. If this time is not
available, the time range will not be met.
Format
config time_range <range_name 32> [hours start_time <time hh:mm:ss> end_time <time
hh:mm:ss> weekdays <daylist> | delete]
Parameters
time_range - Specify the name of the time range settings.
<range_name 32> - Enter the time range name used here. This name can be up to 32
characters long.
hours - Specify the time of a day.
start_time - Specify the starting time of a day.
<time hh:mm:ss> - Enter the starting time here. (24-hr time). For example, 19:00 means
7PM. 19 is also acceptable. The time specified in the start_time parameter must be
smaller than the time specified in the end_time parameter.
end_time - Specify the ending time of a day. (24-hr time)
<time hh:mm:ss> - Enter the ending time here. (24-hr time). For example, 19:00 means
7PM. 19 is also acceptable. The time specified in the start_time parameter must be
smaller than the time specified in the end_time parameter.
weekdays - Specify the list of days contained in the time range. Use a dash to define a period of
days. Use a comma to separate specific days.
<daylist> - Enter the weekdays that will be included in this configuration here. For example,
mon-fri (Monday to Friday). sun, mon, fri (Sunday, Monday and Friday)
delete - Deletes a time range profile. When a time_range profile has been associated with ACL
entries, deleting the time_range profile will fail.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Mode : trTCM / ColorBlind
CBS(Kbyte):2000
Replace DSCP: 60
98
PIR(Kbps):2000
Counter: Enabled
Counter: Enabled
Counter: Disabled
PBS(Kbyte):2000

Advertisement

Table of Contents
loading

Table of Contents