Table of Contents
Advertisement
RECOMMENDED TOOLS & MATERIALS
Adhesives:
Instant setting Cyanoacrylate adhesive (thin CA)
Slow setting Cyanoacrylate adhesive (thick CA)
10 Minute Epoxy (fast)20~30 Minute Epoxy(slow)
You will need two types of adhesives for the A109 Epoxy
and Instant (cyanoacrylate) adhesives. We recommend
that you purchase both 5-minute and 30-minute epoxy to
cut down on assembly time, but you can get by with only
30-minute epoxy if time is not important. You will also
need a small bottle of both "Thick" and "Thin" instant CA
adhesive.
ITEMS YOU MAY NEED
TTR1111 - 3-way Fuel Filter
TTR1112 - AL. Fuel Filter
R/C System:
6 Channel Heli radio req'd
GYRO system req'd
Helicopter:
Raptor 90 SE kit Suggested
TTR4891
- Raptor 90 SE KIT
PRE-ASSEMBLY NOTES
Tools:
Model Knife, 1/2" MASK Tape, Small & Medium Screw-
drivers, Scissors, Long nose Pliers, Drill and Drill Bits
(1/8", 5/64"), 150 Grid Sand Paper, Rat Tail and half-
round file, Fine Felt Tip Pen & Soft Lead Pencil, Reamer,
Hex Wrenches.
Model assembly can be much easier if the proper tools
are used. Therefore, we have included in our checklist
to the left, a complete listing of all the tools we used to
assemble our prototype models. As you will notice,
m a n y h o u s e h o l d t o o l s c a n b e u t i l i z e d d u r i n g
construction.
Ignition Extension.
3
Advertisement
Table of Contents
