Table of Contents
Advertisement
37. Install the tail transmission and link in place. Make
sure it works properly.
40mm
147mm
38. Cut tail end into two pieces as shown.
template in page 15, cut the template off and apply on
tail end then trim off the area.
39. Install the tail in place and trim the contact areas
with tail transmission.
28mm
63mm
Use the
13
40. Secure the tail end with 2x5mm wood screws.
41. Trim all windshield and windows. Both sand the
glue area to enhance the adhesion. You may skip
installing the middle windows for easy access and
tuning the helicopter. This also help the cooling.
42. Epoxy the small screen inside the front fuselage as
shown.
Advertisement
Table of Contents
