Table of Contents
Advertisement
49. Install the rotor head back to the helicopter, make
sure all links are well connected and servos work fine.
50. Cut the front fuselage then join the front fuselage to
the rear fuselage with 16 pieces of 2x5mm wood screws.
Congratulations! Now you are finished the assembly of
this beautiful scale body.
1.When hovering your 109, try to keep your rotor speed
at approximately 1500 RPM.
2.Check the helicopter and fuselage to see if any screw
loosened after each flight.
3.Trim the elevator or rudder when switching on the idle
when you process the speed flight if necessary.
Template for Tail End Opening
15
Advertisement
Table of Contents
