Table of Contents
Advertisement
31. Install the ignition extension outlet on fuselage.
32. Drill about 14mm(5-1/2") hole at the bottom fuselage
where is 35mm (1-3/8") away from the panel line. Get
the silicone tube exit at the hole.
33. Assemble the carbon rod with two rod ends. Next
install the other two body retainers and carbon rod with
two 3x8mm, four 3x10mm socket screws, M3 washers
and locknuts.
34. Drill 3mm hole at the bottom fin of leading edge then
epoxy the tail skid inside the fin about 36mm(2-1/2").
35. Locate 3x25mm setscrews then install on horizontal
tail. Apply epoxy inside the hole and thread the
setscrew in the tail and leave about 10mm in length
outside the tail.
36. Drill a hole to accommodate the setscrew on tail.
Trial fit the tail in place, lightly sand the glue area then
epoxy the tails in place firmly.
12
Advertisement
Table of Contents
