Table of Contents
Advertisement
25. Make sure the helicopter and retract are well
positioned. Carefully remove the socket screw, next
use the hole as drilling guide then drill a pilot hole.
Next enlarge the hole to 3mm.
26. Temporally secure the wood mount at the hole you
drew in the last step. Next using the four holes on main
plate as drilling guide then drill pilot holes. Enlarge the
hole to 3mm.
27. Drill 3mm holes at the marks, secure the retainer
with 3x10mm socket screw with M3 washers and
locknut. Secure the wood mount and main plate with
two
3x25mm Socket Screw, POM washer and M3 nut at
far-most two holes.
28. Locate foot step accessories then use care to
install the foot step support on the fuselage, make sure
they are level with each other. Press the retaining
collar firmly then apply CA at the last.
29. Locate the tail boom foam retainer, measure at
18cm(7") from the boom end. Secure foam retainer in
place with CA.
30. Before you install the helicopter into fuselage, get
an extension wire for retract servo. Carefully install the
helicopter in the fuselage, pull the tail boom and
position the helicopter in place properly. Secure the
helicopter with 3x35mm socket screw, POM washer
and M3 Locknut.
11
Advertisement
Table of Contents
