Table of Contents
Advertisement
1. Get your Raptor 90 well tuned before you install the
body. Remove the tail transmission, landing skid and
rotor head.
2. Locate the landing gear includes retracts, wires,
wheels, collars, POM washers, wheel spacers and
setscrews.
3. Secure the main retract wire with the setscrew which
is already in the retract shaft. Adjust the wire at 50mm
(1-31/32") in length then insert POM washer, wheel
then secure the collar with setscrew.
4. Same way to assemble the nose gear and adjust the
wire at 65mm( 2-1/2 ") in length.
5.Locate the main plate, retract mount, servo tray, M3
locknuts,
standoff, 3x12mm and 3x25mm socket
screws as shown in the photo.
6.Secure the retract mount and the servo tray on the
main plate. Next locate retract gear, 3x10mm sink head
screw, M3 locknut, retract servo, 3x12mm socket
screw, M3 locknut and washer as shown.
7
Advertisement
Table of Contents
