Table of Contents
Advertisement
13. Assemble the pushrods; one is about 95mm between
two center points of ball end, the other is about 465mm
of two ball end center.
14. Temporally install the retract assembly on the
wood mount then install the pushrods to link the front
and rear horn as well as the nose gear pushrod. Test
the retract gear and adjust the pushrods until it works
perfectly.
15. Epoxy the two pieces of screen and exhaust pipes in
place.
16. Install the handle rail at the tail, it is about 27cm
from the end. Drill 2mm holes and press plastic collar
to secure it in place. Apply tiny CA at the contact area
of handle rail and fuselage.
17. Remove the retract assembly from wood mount.
Next remove one side of retract from main plate so it
could be placed in the retract area of the fuselage.
18. Install the retract you just removed from the main
plate as shown.
9
Advertisement
Table of Contents
