The Cutting Unit's Service Position - Husqvarna PT-26D Operator's Manual

Maintenance

The Cutting Unit's Service Position

In order to provide good accessibility for cleaning,
repair and servicing, the unit can be set in the service
position. The service position means that the unit is
raised and locked in the vertical position.
Placing in the Service Position
1. The cutting unit must be in the lowered position
and the engine off.
2. Disconnect both quick couplings for the propeller
shaft under the service hatch and remove the
propeller shaft.
IMPORTANT INFORMATION:
Never leave the propeller shaft on the machine with
one end detached. If the engine starts, damage might
occur.
3. Start the engine and raise the cutting unit to the
transport position.
4. Stop the engine.
102
Service position
Propeller shaft
8009-765
8009-762