Activating/Deactivating Auto Answer; Changing The Speaker/Earpiece Volume - Gigaset C590 Manual

Handset settings
§Save§
Press the display key.
When the screensaver conceals the display,
briefly press a to show the idle display.
Setting large font
You can increase the font size of print and
symbols in call lists and in the directory to
improve readability. After doing this, only
one entry instead of multiple entries can be
shown at the same time on each display and
names are shortened where necessary.
Ï
¢ ¢
v
Display
§Change§
Press display key (³= on).
Setting the colour scheme
You can set the display to have a dark or light
background.
Ï
¢ ¢
v
Display
Colour Scheme 1
Select
§OK§
and press .
•
Setting the display backlight
Depending on whether or not the handset is
in the base/charging cradle, you can activate
or deactivate the lighting. If it is activated,
the display is permanently dimmed. If the
backlight is deactivated it is switched on by
pressing any key. In this case the pressed key
has no other function.
Ï
¢ ¢
v
Display
The current setting is displayed.
¤
Change multiple line input:
In Charger
Select On or Off.
Out of Charger
Select On or Off.
Please note
With the On setting, the standby time
of the handset can be significantly
reduced.
§Save§
Press the display key.
62
¢
Large Font
¢
Colour Schemes
Colour Scheme 2
or
¢
Backlight
•
Activating/deactivating
auto answer
If you activate this function, when you
receive a call you can simply lift the handset
out of the base/charging cradle without hav-
ing to press the talk key c.
Ï
¢ ¢
v
Telephony
§Change§
Press display key (³= on).
Changing the speaker/
earpiece volume
You can set the loudspeaker volume for
handsfree talking and the earpiece volume
to five different levels.
In idle status:
t
Call up the Handset Volume
menu.
r
Set the earpiece volume.
s
Scroll to the Speaker: line.
r
Set the speaker volume.
§Save§
Press the display key if neces-
sary to save the setting perma-
nently.
Setting the volume during a call:
t
Press the control key.
r
Select volume.
The setting will automatically be saved after
approximately 3 seconds, if not then press
§Save§
the display key .
If t is assigned to another function,
¢
e.g. call swap ( page 31):
§Options§
Open menu.
Volume Select and press
Configure setting (see above).
Please note
You can also set the call volume using the
¢
menu ( page 27).
¢
Auto Answer
§OK§
.