Remote Control - Nokia MEDIA MASTER 211S User Manual

Remote control

This section describes how to operate the Mediamaster using the buttons on the remote control. The
stand-by button has double functionalitys. One function is performed if you gently press the button once
and the other function is performed if you hold the button down for a few seconds.
Some of the functions can also be performed using the buttons on the front panel.
Press once to turn the sound off/on (mute). Press and hold
for a few seconds to switch the Mediamaster in and out of
stand-by mode.
0 - 9 Change the channel and select individual menu options.
Note: If 0 is entered as the first digit, the TV Release func-
tionality is activated (see below).
0 TV Release. To switch between digital TV/Radio, analogue
TV and analogue satellite TV and VCR.
info To display short and extended information (if transmitted)
about current and forthcoming programmes. Shows the
viewing banner in viewing mode.
back Go back one level at a time within menus without storing any
settings. To toggle between the current and previous TV/Ra-
dio channel in viewing mode. Close the NaviBars.
select Confirm choices and the selection of a highlighted item.
Open the NaviBars.
opt Show service options in viewing mode.
txt Press to show teletext (if available).
The cursor button
Move up through the menus
and change to the next chan-
nel in the current channel list
while in viewing mode.
Cursor left
Move left/change set-
tings in menus.
Decrease the volume
level while in viewing
mode.
Move down through the
menus and change to the
previous channel in the cur-
rent channel list while in
viewing mode.
Cursor up
Move right/change settings in
menus.
Increase the volume level while
in viewing mode.
The Mediamaster's maximum
volume level is controlled by the
TV's present volume setting.
Cursor down
Cursor right
GB 11