Table of Contents
Advertisement
Step 9
Use two 4-40 x 3/8-inch socket head screws and two
#4 washers to secure the front of the battery tray in the
fuselage. Use a 3/32-inch ball driver or hex wrench to
tighten the screws after applying a drop of threadlock
on each screw.
Hangar 9 Saratoga Assembly Manual
Step 10
Connect the motor and speed control leads. Make sure to
secure them so they will not interfere with the operation of
the motor.
Step 11
Prepare the four 4-40 x ½-inch socket head screws by
sliding a #4 washer on each screw, then a ¼-inch piece of
fuel tubing on the screw. The fuel tubing keeps the screws
from vibrating loose without the need for threadlock.
Step 12
Use the screws from the previous step to secure the cowl
to the fuselage. The screws are tightened using a 3/32-ball
driver or hex wrench.
Step 13
Slide the propeller adapter into the spinner backplate. It may
be necessary to enlarge the hole in the backplate to fit the
adapter.
29
Advertisement
Table of Contents
