Save_Default - ZyXEL Communications VMG1312 Cli Reference Manual

www.zyxel.com
uptime
DESCRIPTION
uptime gives a one line display of the following information. The current time, how long the system
has been running, how many users are currently logged on, and the system load averages for the past 1, 5,
and 15 minutes.
This is the same information contained in the header line displayed by w(1).
System load averages is the average number of processes that are either in a runnable or uninterruptable
state. A process in a runnable state is either using the CPU or waiting to use the CPU. A
process in uninterruptable state is waiting for some I/O access, eg waiting for disk. The averages are
taken over the three time intervals. Load averages are not normalized for the number of CPUs in a
system, so a load average of 1 means a single CPU system is loaded all the time while on a 4 CPU
system it means it was idle 75% of the time.
EXAMPLES
FILES
> cat /var/run/utmp
information about who is currently logged on
NAME
save_default – This command can be use in "save","clean" the customer settings.
SYNOPSIS

save_default

DESCRIPTION
save_default can be use in "save","clean" the customer settings, when customer used any command in CLI
mode to configure CEP then use save_default command to save or restore to default.
COMMANDS
save_default save
save_default clean
save_default show
OPTIONS
ZyXEL Confidential
SAVE_DEFAULT
60