ZyXEL Communications VMG1312 Cli Reference Manual page 117

www.zyxel.com
[--add <port_mask.vpi.vci> aal0pkt|aal0cell [<tdte_index>]]
[--add <port_mask.ptmpri_mask> <mpaal_priority> <mpaal_weight> [<tdte_index>]]
[--delete <port_mask.vpi.vci>|<port_mask.ptmpri_mask>]
[--addq <port_id.vpi.vci>|<port_id.ptmpri_id> <size> <priority> [wrr|wfq <weight>]]
[--deleteq <port_id.vpi.vci>|<port_id.ptmpri_id> <qid>]
[--state <port_mask.vpi.vci>|<port_mask.ptmpri_mask> enable|disable]
[--show [<port_mask.vpi.vci>|<port_mask.ptmpri_mask>]]
[--sendoam <port_id.vpi.vci> f5seg|f5end|f4seg|f4end]
[--createnetdev <port_mask.vpi.vci>|<port_mask.ptmpri_mask> <netdevname>]
[--deletenetdev <port_mask.vpi.vci>|<port_mask.ptmpri_mask>]
port_mask: bit mask of one or more port ids
port_id:
0x01 = PORT_PHY0_LATENCY0
0x02 = PORT_PHY0_LATENCY1
0x04 = PORT_PHY1_LATENCY0
0x08 = PORT_PHY1_LATENCY1
ptmpri_mask: bit mask of one or both PTM priority ids
ptmpri_id:
0x01 = PTM_PRI_LOW
0x02 = PTM_PRI_HIGH
DESCRIPTION
This command is Linux command line utility that controls the Broadcom BCM6368 ATM/PTM driver. It
does the following:
starts and stops the driver
restarts the XTM driver with its own pre-configuration & SAR reinitialization actions.
activates and deactivates an ATM/PTM interface (port)
adds and removes traffic descriptor table entries
adds and removes ATM/PTM connections
displays the configuration for traffic descriptor table entries, ATM/PTM interfaces and ATM/PTM
connections.
displays statistics for ATM/PTM interfaces
sends an ATM OAM F5 or OAM F4 cell
creates and deletes an ATM/PTM network device instance
OPTIONS
None
EXAMPLES
None
ZyXEL Confidential
<mpaal_priority> <mpaal_weight> [<tdte_index>]]
117