Defaultgateway - ZyXEL Communications VMG1312 Cli Reference Manual

www.zyxel.com
cat [FILE] ...
DESCRIPTION
Concatenates FILE(s) and prints them to standard output
COMMANDS
None.
OPTIONS
None.
EXAMPLES
° Display system memory
> cat /proc/meminfo
NAME
defaultgateway – configure or show the default gateway or default route
SYNOPSIS
defaultgateway config [<interface(s) sperated by ',' with NO SPACE.
eg. ppp0 OR for multiple interfaces ppp0,ppp1>]
defaultgateway show
defaultgateway --help
DESCRIPTION
The primary use of defaultgateway command is to set up a static default gateway or default route, or to
retrieve the default gateway information automatically from remote ISPs through DHCP protocol for a
IPOE interface or through PPP protocol for a PPPoA or PPPoE interface. A PPPoA or PPPoE interface
will always retrieve remote gateway information automatically. This command will save configuration to
the Permanent Storage.
If the default gateway is configured with static data, it will override any remote gateway address received
automatically from some WAN interface and become effective immediately in the runtime system.
Ipaddress is optional if the default route is en route a PPPoE, PPPoA or IPoA interface. If the default
gateway is en route a IPOE interface, ipaddress must be configured and the interface parameter is optional.
If there is only one IPoA WAN interface, you must configure static default gateway or default route since
ZyXEL Confidential

DEFAULTGATEWAY

22