Releasing The Isofix Connectors; Placing The Child Seat In The Car - CYBEX JUNO-FIX User Manual

y
x
14
v
w
a

RELEASING THE ISOFIX CONNECTORS

Carry out the installation steps in reverse order.
• Release the ISOFIX connectors (w) on both sides, by pressing and
pulling back the red release buttons (y).
• Pull the seat out of the ISOFIX guides (u).
• Turn the ISOFIX connectors (w) 180°.
• Activate the handle (v) on the underside of the child seat and push the connectors
in until they reach the end position.
NOTE! Retracting the connectors not only protects the car seat, but also protects
the ISOFIX CONNECT system from dirt and damage.

PLACING THE CHILD SEAT IN THE CAR

• Place the child seat on the appropriate seat in the car.
• To install the seat in an upright position for the child it is essential to take
care that the backrest (a) of the child seat lies flush against backrest of
the car seat.
• You can adjust this distance with the handle (v) on the underside of the child seat.
• If the headrests of the car seats get in the way, pull these completely out, turn
them round, or detach them completely (exception see section „THE BEST
POSITION IN THE CAR"). The backrest (a) adjusts itself in one movement to
almost every position of the car seat.
!
Warning! The CYBEX JUNO-fi x backrest must lie fl ush with the back of the car
seat. In order to guarantee maximum protection for the child, the seat must be
in a normal, upright position.
NOTE! It is possible that some car seats that are made of soft material (e.g.
velours, leather, etc.) may show signs of usage and/or discolouration. In order to
avoid this, you could, for example, place a cover or towel underneath it. In this
context, we would also like to refer to you to our cleaning instructions, which
must absolutely be followed before the fi rst use of the seat.