Table of Contents
Advertisement
General Inspection
Check electrical wiring and compo-
nents, retighten loose connections.
Check for stripped wires or damaged
insulation. Thoroughly inspect the ve-
hicle and tighten loose bolts, nuts and
linkage. Inspect ski and ski runner for
wear.
Bulb Replacement
If headlamp is burnt, remove hood. Un-
plug connector from headlamp. Re-
move rubber boot and unfasten bulb
retainer clips. Detach bulb and replace.
If taillight bulb is burnt, expose bulb by
removing
red plastic lens. To remove,
unscrew the two (2) Phillips head
screws). Verify all lights after replace-
ment.
STORAGE
+
WARNING: Only perform such
procedures as detailed in this
manual. It is recommended that dealer
assistance be periodically obtained on
other components / systems not cov-
ered in this manual. Unless otherwise
specified, engine should be turned OFF
for
all lubrication
and maintenance pro-
cedures.
Tracks
Inspect tracks for wear, cuts, missing
tracks inserts or broken rods and make
any necessary replacement.
+
WARNING: Do not operate a
snowmobile with a cut, torn or
damage track.
Lift rear of
vehicle
until tracks are clear
of ground, then support it with a brace
or trestle. The snowmobile should be
stored in such a way that the tracks
does not stay in contact with cement
floor or bare ground.
O
NOTE: The tracks should be ro-
tated
periodically,
(every
40
days). Do not release track tension .
. . . CAUTION: To prevent track
dam-
. . age, temperature in the storage
area must not exceed 38° C (100° F).
Suspension
Remove the bogie wheel sets from the
vehicle. Remove cross shaft from bogie
wheel set. Clean bogie wheel assembly
and cross shaft of dirt or rust. Grease
each bogie wheel until a old grease is
flushed out. Spray bogie wheel springs
With metal protector. If unavailable
wipe with cloth or rag soaked in oil
~
Check condition of shaft and replace if
bent or worn. Apply a coat of low
temp. grease on cross shaft.
27
Hide quick links:
Advertisement
Table of Contents
