Installing The Battery - Nonin GO2 LED Achieve User Manual

• Radios and cell phones or similar devices may affect the GO
kept at least 7 feet away from the device.
• Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
telephones and land mobile radios, amateur radio, AM and FM radio broadcast towers
and TV broadcast towers may affect accuracy.
• Use in emergency vehicles with communication systems may affect accuracy.
• Functional tester cannot be used to assess the accuracy of this pulse oximeter.
• Follow local disposal and recycling laws for the GO
including the battery.
• The GO LED Achieve is a precision electronic instrument and must be repaired by Nonin
2
Technical Service.
7
LED Achieve and should be
2
LED Achieve and its components,
2

Installing the Battery

One 1.5 volt AAA-size (LR03) battery powers the GO
2,400 measurements. Nonin recommends using alkaline batteries (one is included with
each new GO LED Achieve). NOTE: You may use rechargeable batteries; however, they
2
may require more frequent replacement.
1. Remove the battery door located on the left side of the GO
it towards you (see page 9 diagram).
2. Insert one new 1.5 volt AAA-size battery. Follow the plus (+) and minus (-) markings
for battery direction (as shown inside of the battery compartment).
LED Achieve for approximately
2
LED Achieve by sliding
2
8