Lenovo HS23 Installation And User Manual page 60

3. Make sure that the release handles on the blade server are in the open position
4. Slide the blade server into the blade bay until it stops.
5. Push the release handles on the front of the blade server to the closed position.
6. Turn on the blade server (see "Turning on the blade server" on page 14 for
7. Make sure that the power-on LED on the blade server control panel is lit
8. If you have other blade servers to install, do so now.
9. Optional: Write identifying information on one of the labels that come with the
If this is the initial installation of the blade server in the BladeCenter unit, you
must configure the blade server through the Setup utility and install the blade
server operating system. See "Updating the blade server configuration" on page 49
and Chapter 5, "Installing the operating system," on page 67 for details.
If you have changed the configuration of the blade server or if you are installing a
different blade server from the one that you removed, you must configure the
blade server through the Setup utility, and you might have to install the blade
server operating system. For more information, see "Using the Setup utility" on
page 52.
48
BladeCenter HS23 Types 7875 and 1929: Installation and User's Guide
(perpendicular to the blade server).
Note: After the blade server is installed, the IMM2 in the blade server
initializes and synchronizes with the management module. This process takes
approximately two minutes to complete. The power-on LED flashes rapidly,
and the power-control button on the blade server does not respond until this
process is complete.
instructions).
continuously, indicating that the blade server is receiving power and is turned
on.
blade servers and place the label on the BladeCenter unit bezel. See the
documentation for your BladeCenter unit for information about the label
placement.
Important: Do not place the label on the blade server or in any way block the
ventilation holes on the blade server.