Table of Contents
Advertisement
7. Using your fingers, pull the DIMM out of the connector.
8. Install a DIMM or DIMM filler in each empty DIMM connector (see "Installing
Installing a microprocessor and heat sink
Use this information to install a microprocessor and heat sink in the blade server.
The following notes describe the type of microprocessor that the server supports
and other information that you must consider when you install a microprocessor:
v Each microprocessor socket must always contain either a socket cover and
v If you are installing a second microprocessor, make sure that the microprocessors
v Before you install a new microprocessor, download and install the most current
v When you install a second microprocessor, you might have to install additional
v The microprocessor installation tool might become worn after several uses. Make
The following illustration shows how to install a microprocessor and heat sink in
the blade server.
Note: To access DIMM connectors seven through twelve, use your fingers to
lift the DIMM access door.
a memory module" on page 27).
Note: DIMMs or DIMM fillers must occupy DIMM connectors 1, 2, 13, 14, 15,
and 16 for proper cooling.
heat-sink filler or a microprocessor and heat sink. If the blade server has only
one microprocessor, it must be installed in microprocessor socket 1.
are identical.
level of UEFI code (see "Updating firmware and device drivers" on page 60).
memory, or redistribute memory across the DIMM connectors (see "Installing a
memory module" on page 27).
sure that the tool can hold the microprocessor securely if you are reusing an
existing microprocessor installation tool. Do not return the tool with other parts
that you are returning.
Chapter 3. Installing options
31
Advertisement
Table of Contents
