Audio Setup - Sony NXCAM HXR-NX100 Operating Manual

Adjusting the color tone
(Continued)
2 Press the WHT BAL button B to
highlight the white balance value.
3 Select A (
manual lever.
4 Press the MENU button.
5 Press the V/v/B/b/SET buttons to select
(CAMERA SET) t [WB SET].
6 Frame a white object such as a piece of
paper that fills the screen under the
same lighting conditions as your
subject.
7 Press the SET button.
The adjusted value is stored in
B. The stored color temperature
appears for about 3 seconds.
z Tip
• [WB SET] is assigned to the ASSIGN1/WB
SET button. The adjusted value is stored by
pressing the ASSIGN1/WB SET button when
the shooting screen is displayed, instead of
performing step 4 to 7.
b Note
• When a white balance adjustment value has not
been obtained successfully,
starts flashing slowly. Adjust the subject
appropriately and set the shutter speed to auto or
around 1/60 (60i models)/1/50 (50i models),
then try adjusting the white balance again.
To restore automatic adjustment
Press the WHT BAL button B.
b Note
• When you turn the FULL AUTO button C on,
all other manual adjustments (iris, gain, and
shutter speed) are also released.
42
A) or B ( B) using the
A or

Audio setup

The jacks, switches and dials shown below
allow you to set the sound that is recorded.
See page 5 for details about connecting a
microphone.
A or
B
External audio input and selection
A: INPUT1 jack
B: INPUT2 jack
C: INPUT1 (LINE/MIC/MIC+48V)
switch
G: INPUT2 (LINE/MIC/MIC+48V)
switch
Audio source switches
D: CH-1 (INT MIC/EXT/MI SHOE)
switch
H: CH-2 (INT MIC/EXT/MI SHOE)
switch