Network Setup (Lan Cable Connection) - Kyocera 6551ci Operation Manual

Installing and Setting up the Machine > Default Settings of the Machine

Network Setup (LAN Cable Connection)

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),
TCP/IP (IPv6), IPX/SPX, NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX, NetWare
and other platforms.
This section explains the procedure of IPv4 and Bonjour settings for TCP/IP settings. For other network settings, refer to
the Network on page 8-43.
NOTE
If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user authentication screen appears. Enter a login user name and
password, and press [Login].
The factory default login user name and login password are set as shown below.
6551ci
7551ci
TCP/IP Settings
IPv4 setting
Set up TCP/IP (IPv4) to connect to the Windows network.
The default settings are "TCP/IP Protocol: On, DHCP: On, Auto-IP: On".
NOTE
• Ask your network administrator for the IP address in advance, and have it ready when you configure this setting.
In the following cases, set the IP address of DNS server on the Command Center RX.
• When using the host name with "DHCP" setting set to "Off"
• When using the DNS server with IP address that is not assigned by DHCP automatically.
Refer to the Command Center RX User Guide.
1
Model Name
6500
7500
Display the screen.
1
Press the [System Menu] key and select [System/Network].
1
Login User Name
6500
7500
2-27
Login Password
System Menu
Quick Setup Wizard Cassette/MP Tray Settings
Common Settings Home
Copy Send
Document Box/Removable
FAX
Memory
2
Printer Report
System/Network
1/2
Close