Calibrating The Sensors - Miele KM 5987 Operating And Installation Instructions

Calibrating the sensors

Automatic calibration
To ensure continuing trouble-free
operation, the sensors
– are recalibrated after the appliance
is connected and after every power
interruption, such as an electricity
outage.
The safety lock indicator light comes
on during automatic calibration and
the cooktop cannot be switched on.
– continuously adjust to changing
environmental conditions during
operation.
If the automatic calibration cannot be
successfully performed, an A lights in
the front left and right cooking zone
display and an F in the rear left of the
display. Numbers light up in the right
rear of the cooking zone display and in
the Timer/Memory display.
In that case, you can perform the
calibration manually.
Before the first use
Manual calibration
^ First ensure that no direct light (either
sunlight or artificial light) is falling on
the cooktop. As well, the area around
the cooktop should neither be too
dark nor should the lighting
conditions be constantly changing.
^ Make sure there is nothing covering
the entire cooktop and the sensors.
Remove any cookware and clean any
food residues off the cooktop.
^ Interrupt the power supply to the
cooktop for approximately 1 minute.
Restore the power. The electronic until
will reset the sensitivity levels of the
sensors.
Should the problem still persist, please
call customer service.
15