Steam Flow Adjustment; Adjusting The Turbocream Nozzle (If Fitted) - Victoria Arduino ADONIS 2 gruoups Manual

Hide thumbs Also See for ADONIS 2 gruoups:

Table of Contents

Enlarged version

6.4 STEAM FLOW ADJUSTMENT

Use the dial to increase/reduce the flow of steam inject-

ed into the milk, as illustrated in the following figure.

6.5 ADJUSTING THE TURBOCREAM

NOZZLE

(If Fitted)

To increase/reduce the amount of air injected into the

milk from the TurboCream nozzle (and therefore to

increase/reduce the amount of foam in the heated milk)

proceed as illustrated in Fig. 19:

Loosen the stainless steel tube (1) as illustrated in

Fig. 19.A.

To increase/reduce the amount of air, tighten (turn-

ing clockwise) or loosen (turning anticlockwise) the

Fig. 18

Teflon tube (2) as illustrated in Fig. 19.B.

Tighten the stainless steel tube again.

Fig. 19.A

Fig. 19.B

NOTE

By reducing or increasing the length (tightening or

loosening) the tube/Teflon tube by a few fractions of a

mm/mm, there is a significant difference in the amount

of foam in the heated milk.

Fig. 19

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the ADONIS 2 gruoups and is the answer not in the manual?

Adonis 3 gruoups