Victoria Arduino ADONIS 2 gruoups Manual page 22

• Press ENTER and the display will read:
AUT O. C L E A N. CYC L E
S E L E C T
• The central key in each unit
flash on and off. Insert the blind filter (Fig 2 A06)
into the filter-holder, add half a dose of PULICAFF
and attach the filter-holder into the unit where you
intend to carry out the automatic cleaning cycle.
Carrying out a cleaning cycle in more than one unit
at a time is possible.
• Press the key to start the unit automatic
cleaning cycle. The display will read:
AUT O. C L E A N. CYC L E
1L
where 1L indicates that the cleaning cycle has
been activated within the 1st unit. Once the cycle
of 15 deliveries of 5 seconds each, with a 10-
56
second pause between each delivery, has been
completed the selected unit
flash on and off again and the display will read.
• Eliminate any residues of PULICAFF from the blind
will begin to
filter and press
of the unit or units where the cleaning cycle has been
effected. The letter R will remain on the display like the
key . Once the rinsing cycle of the selected unit
or units has been completed, the display will read.
M A CHINE RE A D Y
PROGRAMMING DOSES
• Press the  key to access the programming; the
display will read:
P ROGR A M. DO S E S
• Press ENTER and the display will read:
key will begin to
RIN S E
All the programmable keys will start to flash on and off.
• Press the coffee key you wish to program; the
the rinsing cycle starting up key
Followed by the dose amount already set by the
manufacturers.
• Vary the dose, by pressing the buttons  .
• By pressing the coffee key you want to program,
• Select the dose of delivered coffee and then press
• The display will show the new dose amount which
P ROGR A M. DO S E S
S E L E C T
display will read:
volume c. c :
delivery will be started up (in the meantime all the
other keys will turn off).
the coffee key you want to program again.
can still be changed by means of the keys  .