Before Using - Hitachi C 8FSC Handling Instructions Manual

BEFORE USING

1. Make sure the power source is appropriate for the tool.
WARNING:
2. Make sure the trigger switch is turned OFF.
WARNING
3. Check the saw blade for visible defects.
Confirm that the saw blade is free of cracks or other visible damage.
4. Confirm that the saw blade is attached securely to the power tool.
Using the supplied 10mm box wrench, tighten the bolt on the saw blade spindle to
secure the saw blade.
For details, see Fig. 30-a and Fig. 30-b in the section on "SAW BLADE MOUNTING AND
DISMOUNTING".
5. Check the safety cover for proper operation.
WARNING
6. Confirm the position of the spindle lock before using the tool.
After installing the saw blade, confirm that the spindle lock has been returned to the
retract position before using the power tool (see Fig. 2).
7. Check the lower limit position of the Saw Blade.
Although it was adjusted before shipment, carefully check the height of the saw blade.
Confirm that the saw blade can be lowered 12mm to 13mm (15/32" to 1/2") below the
table insert. For details, see the section on "Checking the saw blade lower limit position".
8. Check the Power Receptacle.
To prevent overheating, accidental stopping or intermittent operation, confirm that the
power cord plug fits properly in the electrical receptacle and does not fall out after it is
inserted. Repair or replace the receptacle if it is faulty.
Never connect the power tool unless the available AC power source
is of the same voltage as that specified on the nameplate of the
tool.
Never connect this power tool to a DC power source.
: If the power cord is connected to the power source with the trigger
switch turned ON the power tool will start suddenly and can cause
a serious accident.
Sub cover
Safety cover
Fig. 8
: NEVER OPERATE THE POWER TOOL if the safety cover does not
function smoothly.
This slide compound miter saw is equipped
with a saw head lock as safety device. To lower
the saw head to cut, the lock must be released
by pressing the lock lever with your thumb.
When you push down the handle while
pushing the lock lever, check that the safety
cover and sub cover revolves smoothly.
Next, check that the safety cover and the sub
cover returns to the original position when the
handle is raised.
13