Hitachi C 8FSC Handling Instructions Manual page 16

4. Oblique angle
5. Securing the workpiece
WARNING:
6. Installing the holders (Standard Equipment)
6mm knob
bolt
Holder
Steel square
7. Stopper for precision cutting (Standard Equipment)
6mm knob bolt
16
8mm nylock
bolt
Fig. 12
Always clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
Base surface
Fig. 13
Workpiece
Stopper Holder
Move
Fig. 14
Before the power tool is shipped from the
factory, it is adjusted for 0°, right angle, Ieft
45° bevel cutting angle with the 8mm nylock
bolts.
The positioning and bevel cutting angle can
be adjusted by loosening the 8mm nylock bolt
and by changing the height of the 8mm nylock
bolt.
(Maximum bevel cutting angle is 45°)
The holders help keep longer workpieces
stable and in place during the cutting
operation.
(1) As indicated in Fig. 13, use a steel square
for aligning the upper edge of the holders
with the base surface.
(2) After aligning, secure the holders with the
6mm knob bolts.
The stopper facilitates continuous precision
cutting in lengths of 265mm to 430mm (10-7/
16" to 16-15/16").
To install the stopper, attach it to the holder
with the 6mm knob bolt as shown in Fig. 14.