Electrical Units; Alternator; Specification And Performance; Structure - Shibaura CM214 Workshop Manual

2-3 Electrical Units

1. ALTERNATOR

1) Specifications and performance
Part code No.
Type
Rotating direction
Working rpm
Charging performance
Charging start speed
Regulator combined

3) Disassembly, Inspection and Reassembly

Disassembly
When the alternator is defective or the flywheel turns
abnormally, disassemble the alternator as explained below.
(1) Hold the pulley side jaw of the flywheel COMPL
with a vice, loosen the nut.
(2) Pull out the spring washer and washer.
(3) Pull out the flywheel COMPL. (If it is hard to remove,
tap the M10 threads with a plastic hammer.)
(4) Disconnect the coupler terminal stopper from the
plate COMPL.
(5) Loosen the M4 screw and remove the clamp.
(6) Remove the M4 screw.
(7) pull out the stator COMPL from the coil plate.
(8) Position the coil plate rear side on the surface plate,
and insert a rod having diameter of approximately 24
mm.
Then, push the bearing with a press to pull it out.
(Replace the front bearing as a flywheel COMPL.)
NOTE: Never clamp the flywheel body with any
vice.
185046400
GP9165
Clockwise
(viewed from pulley end)
1300 – 5000 rpm
20 A – 21 A at 12 V, 4500 rpm
Less than 1300 rpm
RS5137

2) Structure

1. Flywheel COMPL
2. Plate COMPL
3. Coil plate
4. Stator COMPL
5. Bearing
6. Collar
7. Nut
45
178V
179V
8. Spring washer
9. Washer
10. Coupler
11. Clamp
12. Screw
13. Screw
180V