Adjusting Lcd Monitor/Viewfinder - Panasonic VDR-D310PL Operating Instructions Manual

LSQT1150.book 43 ページ ２００７年１月１９日 金曜日 午前９時２７分
≥ The date and time function are driven by a
built-in lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
To recharge the built-in lithium battery
Connect the AC adaptor or attach the battery
to the unit, and the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (Even if the OFF/
ON switch is set to OFF, the battery is still
being recharged.)
Adjusting LCD monitor/
viewfinder
Adjusting the brightness and
color level
1
Press the MENU button, then
select [SETUP] # [LCD SET] or
[EVF SET] # [YES] and press the
joystick.
2
Move the joystick up or down to
select the item to be adjusted.
Then, move the joystick left or
right to make the adjustment.
The bar display moves.
∫ [LCD SET]
[BRIGHTNESS]:
Brightness of the LCD monitor
[COLOR]:
Color level of the LCD monitor
∫ [EVF SET]
[BRIGHTNESS]:
Brightness of the viewfinder
≥ To adjust the brightness of the viewfinder,
extend the viewfinder and close the LCD
monitor to activate the viewfinder.
≥ When the LCD monitor is rotated by 180°
towards the lens, the brightness and color level
of the LCD monitor cannot be adjusted.
≥ These settings will not affect the images
actually recorded.
Adjusting the field of view
Adjust the focus by sliding the
eyepiece corrector knob.
MENU
0h00m00s 0h00m00s 0h00m00s
Setup
0h00m00s
43
LSQT1150