Wiring And Connection - JinkoSolar JKM200P-60 User Manual

Module type Cell type
JKMXXXP-72
JKMXXXPP-72
JKMXXXP-72B
JKMXXXPP-72B Poly
JKMSXXXP-72
JKMSXXXPP-72
JKMxxxPP-72(Plus)
JKMXXXM-72
JKMXXXM-72B Mono
JKMSXXXM-72
JKMXXXP-60
JKMXXXPP-60
JKMXXXP-60B
JKMXXXPP-60B Poly
JKMSXXXP-60
JKMSXXXPP-60
JKMxxxPP-60(Plus)
JKMXXXM-60
JKMXXXM-60B Mono
JKMSXXXM-60
Table 1 above: Mechanical dimensions when modules installed at long side with Clamp

3. Wiring and connection

a) Before this procedure, please read the operation instructions of the PV system
carefully. Make wiring by Multi-connecting cables between the PV modules in
series or parallel connection, which is determined by user's configuration
requirement for system power, current and voltage.
b) PV module connected in series should have similar current, and modules must not
be connected together to create a voltage higher than the permitted system
voltage. The maximum number of modules in series depends on system design,
the type of inverter used and environmental conditions.
c) The maximum fuse rating value in an array string can be found on the product
label or in the product datasheet. The fuse rating value is also corresponding to the
Cell
quantity A*B J
6*12 1956*992 400
6*12 1956*992 400
6*10 1650*992 400
6*10 1650*992 400
- 11 -
Rev. C
Dimension(mm)
K M O
≥14
480 5~11 0.5~2mm
≥14
480 5~11 0.5~2mm
≥14
420 5~10 0.5~2mm
≥14
420 5~10 0.5~2mm
N P
＞2mm
＞2mm
＞2mm
＞2mm